Extraflame EcoLogica Idro, Instruction Manual

Page: 20 / 40

Page 20
10.3
Remote control
The heat setting, the room temperature, and automatic start/stop of the stove can be remote
controlled.
S = Light that indicates which keys have
been pressed.
Correspondence of display keys with
remote control keys
1 = p3+p5
2 = p2
3 = p3
4 = p4
5 = p5
To light the stove, press buttons 3 and 5 at the same time and hold for three seconds (Fig. 21);
the stove automatically enters the lighting stage. This is followed by the start-up phase, which
allows the stove to develop and settle the flame.
When the lighting stage is complete, the stove goes into normal operation. The heat setting can
be adjusted using the buttons
4 and 5 , and the room temperature setting can be adjusted using
buttons 2 and 3.
To switch off the stove, press buttons 3 and 5 at the same time and hold for three seconds.
Display D1 will show the message “ OFF ”.
The remote control operates with an MN21 12V battery (the kind used for gate opening remote
controls).
To replace the batteries, open the cover in the rear part as illustrated below.
Open by pressing the part circled in the figure
P3
P4 P2
P5
S