Page 27
When you have exited from the programming, to activate/deactivate the function, press button
4
and hold it down, press button
5
, then release both buttons at the same time.
The corresponding LED on the control panel will light up/go off (see description in the display
messages table).
N.B. The stove must always be shut down while setting parameters.
Summary table
Display D1 Display D2
Function
06:00
B
Start day phase/end night phase
22:00
C
Start night phase/end day phase
25°C
D
Day phase max. temperature
20°C
E
Night phase max. temperature
Once this function is active, it is still necessary to light the stove using button 1. When the stove
switches off because the maximum temperature has been reached, the message “
doff
” appears
on
D1
.The stove will switch on again automatically when the room temperature is
3
°C lower than
the maximum temperature set.
e.g. Status of the stove –
doff
Max. temperature set – 25°C
When the room temperature goes below 22°C (25 – 3 = 22°C), the stove will automatically start
again.
N.B.: This only occurs if the stove is in “doff” status, not in “off” status.
Manual controls via the front panel or remote control take precedence over any programmed
settings.
Summary of Contents for EcoLogica Idro
Page 6: ...Page 6 ...
