Extraflame COSTANZA IDRO, User Manual

Page: 22 / 44

1
2 3
4
5
6
6
2
3
1
5
4
22 ENGLISH
gENERAL mENU
go back - exit
scroll parameters: next (3); previous (2)
modify data settings: increase (4); decrease (5)
confirm - access menu
BASIC INSTRUCTIONS
The following recommendations must be followed the first times
the stove is ignited:
Š it is possible that slight odours are produced due to the drying
of the paints and silicone used. Do not remain in the room for long
periods.
Š
Do not touch the surfaces as they could still be unstable.
Š
ventilate the room well several times.
Š
The hardening of surfaces will stop after several heating cycles.
Š
This appliance must not be used to burn waste.
Before lighting the stove, the following points must be checked:
Š
The hydraulic system must be completed in compliance with
regulatory guidelines and the instructions in the manual.
Š
The hopper must be loaded with pellets
Š The combustion chamber must be clean
Š The burn pot must be completely free and clean
Š check the hermetic closure of the fire door and the ash drawer
Š
check that the power cable is properly connected
Š
The bipolar switch in the rear right part must be positioned on
1.
J
mAkE SURE THAT THE BOTTOm Of THE BURN POT IS fREE fROm RESIDUE
AND DEPOSITS. THE HOLES AT THE BOTTOm mUST BE COmPLETELY fREE
TO gUARANTEE CORRECT COmBUSTION. THE "EASY SETUP" fUNCTION
CAN BE USED TO ADAPT COmBUSTION ON THE BASIS Of THE NEEDS
DESCRIBED.
Burn poT Base
vENTILATION ENABLINg
SPEED
EASY SETUP SET SET THERMOSTAT
CHRONO ENABLINg
PRg1
PRg2
SETTINgS DATE-TIME PRg3
LANgUAgE PRg4
DISPLAY
STAND-BY
FIRST LOAD
OUTLET AIR
DEgREES
*STOvE STATUS WiFi
*
Technicians onLY
RESET
*MENU
TECHNICIAN