Extraflame COSTANZA IDRO, User Manual

Page: 26 / 44

26 ENGLISH
EASY SETUP
The volumetric weight of the pellet is the ratio between the weight and the volume of the pellet. This ratio may change while keeping the
quality of the pellet unchanged. By using the easY seTup function, it is possible to change the calibration of the volumetric weight by
increasing or decreasing the pre-set values.
in the stove program, the available values go from “– 3” to “+ 3”; all stoves are calibrated during production with the optimal value which is 0.
if you notice an excessive deposit on the burning pot, access the easY seTup program and lower the value to “- 1”; then wait until the next
day and if there is no improvement, decrease again, to a maximum of “- 3”.
instead, if it is necessary to increase the calibration of the volumetric weight of the pellet, go from the factory value “0” to “+ 1, + 2, + 3” as
required.
EXCESSIvE PELLET DEPOSIT IN THE BURN POT NORMAL OPERATION MINIMUM PELLET DEPOSIT IN THE BURN POT
-3 -2 -1 0 +1 +2 +3
ThirD
Decrease
range iF The
FirsT TWo are
noT enough
seconD
Decrease
range iF The
FirsT is noT
enough
FirsT Decrease
range (TesT
For 1 DaY)
opTimaL FacTorY
vaLue
FirsT increase
range
seconD
increase
range iF The
FirsT is noT
enough
ThirD increase
range iF The
FirsT TWo are
noT enough
conTroLs proceDure
Š press key 6.
Š
press key 3 until EASY SETUP appears and confirm by pressing key 6.
Š
use keys 4 and 5 to set the range.
Š
press key 6 to confirm and key 1 to return to the previous menus to the initial state.
N.B.: If THIS CALIBRATION DOES NOT SOLvE THE PELLET DEPOSIT IN THE BURN POT, PLEASE CONTACT YOUR LOCAL AfTER-
SALES CENTRE.
vENTILATION
The menu allows you to enable and adjust the speed (-2, -1, 0, +1, +2) of the front fan.
enaBLing conTroLs proceDure
Š press key 6.
Š
press 3 until vENTILATION appears and confirm by pressing 6.
Š
confirm enaBLing by pressing the 6 key.
Š
use keys 4 -5 to enable ( ON ) or disable ( OFF ) and confirm by pressing 6.
Š
press 1 to return to the previous menus to the initial state.
speeD conTroLs proceDure
Š
press key 6.
Š
press 3 until vENTILATION appears and confirm by pressing 6.
Š Keep pressing 3 until
SPEED
appears and confirm by pressing 6.
Š use keys 4 -5 to adjust the speed (-2, -1, 0, +1, +2) and confirm by pressing 6.
Š press 1 to return to the previous menus to the initial state.
seT ThermosTaT controls procedure
Š
press key 6.
Š press 3 until
vENTILATION
appears and confirm by pressing key 6.
Š Keep pressing 3 until SET THERMOSTAT appears and confirm by pressing 6.
Š
use keys 4 5 to adjust the room temperature (7°c - 37°c) and confirm by pressing 6.
Š
press 1 to return to the previous menus to the initial state.