Extraflame ANGY, User Manual

Page: 26 / 36

26 ENGLISH
depreSSUre nOtIce
It allows you to activate the buzzer for acoustic warnings if the door or the hopper are open.
Please note: Activation can reduce battery life by 30%.
The battery life depends on the usage
To set: OK > SETTINGS > DEPRESSURE NOTICE
radIO prOBe
The RADIO PROBE is an optional accessory that controls the temperature in the installation or ducting room without having to use wired
sensors.
For further details on its use and features, go to the website https://www.lanordica-extraflame.com/it
Š
inFo
Three pieces of information about the Wi-Fi function are available in this menu.
To set: OK > SETTINGS > WIFI > INFO
- MAC: Unique identification code of the Wi-Fi device
- STATUS: Wi-Fi module status; it can have the following values:
Š
SERIAl KO: no communication between Wi-Fi module and stove board
Š
DISCONNECTED: The Wi-Fi module is not configured for internet access
Š
STATION OK: The Wi-Fi module is connected to the home router, but has no access to the cloud (e.g. no Internet access, firewall issues)
Š
ClOUD OK: The Wi-Fi module is connected to the cloud
The firmware revision number of the Wi-Fi module is also indicated.
- RSSI: Wi-Fi signal strength, when it is correctly connected to an access point
The RSSI value is expressed in decibels (dB) as a negative number which is typically in the range between -60dB (excellent signal) and -85dB (very
poor
signal). If the signal is poor, we recommend purchasing a Wi-Fi repeater to avoid any connectivity problems
OperatIOn and SOlUtIOnS
The Wi-Fi module identifies the operation status using the green “Wi-Fi” lED. The table below shows how to interpret the information provided
and the solutions to implement
Wi-Fi LED StatuS EXPLanation SoLution
OFF Module off
Enable the module from the Wi-Fi menu
Check the stove power supply
Contact the technical support service
FlASHINg lED
Connection in progress
The module is attempting to make the connection
to the home network selected.
The module may take up to one minute to
make the connection. If the problem persists,
run a reset and reconfigure the product
ON The product is connected to the server
To deactivate the connection, use the menu
SETTINGS > WI-FI > ENABLING > OFF