1.2 Installing and Charging the Battery Cartridge
Note: One battery cartridge is included with the printer. Similar to a cordless phone battery,
the printer’s battery must be charged before using it.
Extech batteries must be cycled several times to achieve maximum capacity. To
cycle a battery fully charge it and then allow full discharge through normal use in
the printer
1.2.1: Installing the battery
Note: Refer to Figure 2 below to install the battery pack in the printer.
Unlock the battery door by sliding the battery door locking tab down
Open the battery door
Insert the battery as shown. The battery side with two contact terminals should be facing
down to make contact with the two spring probes inside the battery compartment.
Close the battery door.
Lock the battery door by sliding the battery door locking tab up
FIGURE 2: INSTALLING THE BATTERY CARTRIDGE
Note: Ensure the battery is properly seated before closing door. To ensure a full charge do
not operate the printer while charging.
ANDES3 User’s Guide
Rev 1.0
7
