475040 and 475044-EU-EN V2.0 8/12
4
Peak Load Measurement
1.
Slide the POWER switch to the PEAK position...
2.
Touch the adapter to the object being measured in a straight line, refer to Fig. 1.
3.
Zero the meter before each measurement.
4.
Begin measurement by applying force (pull or push). The LCD will display the peak value,
which is the highest reading encountered.
5.
After completing the measurement, the display will hold the peak load value if the position
and angle of the Force Gauge have not changed.
6.
After completing the measurement, the display will over-range if the position or angle of the
Force Gauge has changed. This occurs because the initial force of the transducer
decreases
due to a change in the position or angle of the Gauge after measurement.
Note:
Be sure to press "ZERO" before taking any new measurements.
Fast/Slow selection
Press the FAST/SLOW key to select the desired display update rate. The “((
))” symbol will appear in
the display when FAST is selected.
Mounting
For best results, mount the Digital Force Gauge to a test stand. Mounting holes are provided on the
rear of the meter.
Maintenance
Battery Replacement
The low battery indication appears as a "LO" on the display when battery voltage is less than 6.8V. To
replace the battery:
1.
Remove the two screws from the battery compartment cover.
2.
Lift off the battery cover.
3.
Replace with 6x 1.5V AA (UM-3) batteries. Observe polarity carefully.
4.
Replace compartment cover and screws.
All EU users are legally bound by the Battery Ordinance to return all used batteries to
community collection points or wherever batteries / accumulators are sold!
Disposal in household trash or refuse is prohibited!
Disposal:
Follow the valid legal stipulations in respect of the disposal of the device at the
end of its lifecycle
www.netzerotools.com
www.netzerotools.com
