HOBO® RX3000 RXW Manager (RXMOD-RXW-xxx) Quick Start
22239-E MAN-QSG-RXMOD-RXW
Important:
If you have not already registered the RX3000 station with HOBOlink® and set up the station communications, follow the
instructions in the
HOBO RX3000 Remote Monitoring Station Quick Start
before continuing (go to www.onsetcomp.com/manuals/rx3000-qsg).
1
Stop the RX3000 station and connect to
HOBOlink.
2
Power down the RX3000 station.
3
Install the RXW Manager module.
4
Connect the RXW Manager to the module .
5
Power up the RX3000 station.
6
Update the RX3000 station firmware.
If you added the module to an RX3000 station that was
previously in use, you will need to update the station
firmware. If you have a new station, go to step 7.
a.
In HOBOlink, go to Devices, then RX Devices, and click the
station name.
b.
On the station page, click Overview and scroll down to
Device Information.
c.
On the General tab under the Firmware Version, click the
firmware
upgrade link.
d.
Select Upgrade on Next Connection and click Save.
e.
Press the Connect button on the station to connect to
HOBOlink and start the firmware upgrade.
f.
Wait for the firmware upgrade to complete. The upgrade
icon should be gone in HOBOlink once the upgrade is
successful. If the station firmware is not successfully
installed, it could be because there is an interruption in
cellular service or poor signal strength. Contact Onset
Technical Support for help.
7
Configure the module in HOBOlink.
Set the logging interval for the module in HOBOlink. Go to
Devices, then RX Devices. Select the
icon next to your
station and select Module/Sensor Configuration. Select
Module <1 or 2>: Wireless Sensors Logging, enter a logging
interval, and click Save.
Press the Start button on the RX3000 station to begin logging.
See the HOBOlink Help for details on how to change
connection intervals, view data, check sensor node status, and
more.
Disconnect the battery and unplug any charging device.
Insert the connector on the back of the module into the
receptacle in the left or right module slot. Use a Phillips-head
screwdriver to tighten the screw at the bottom of the module.
Press the Stop button if the station is currently logging and
then press the Connect button to upload the latest data to
HOBOlink.
Plug in the battery and then the charging device, and wait for the
station to power up. Verify that the new module is listed on the LCD
screen with a checkmark. The station should automatically connect
to HOBOlink (press the Connect button on the station if it does not).
Plug the cable from
the RXW Manager
into the jack on the
module, making sure
the cable is inserted
through the bottom
of the station case.
Do not reconnect the
power on the station
until the RXW
Manager is plugged
in as shown.
