4-Port USB2.0 to Ethernet Adapter (USB Server)
2
z
DC Jack and Terminal Blocks Power Connectors:
A 7V~24V DC
Power is required for this product. Power is supplied from either the
DC Jack or the Terminal Blocks, but not both at the same time.
z
RJ45 Ethernet Connector:
10/100Mbps Ethernet port. It supports
auto cross-over feature. You can use the same cable to connect
to either a Hub/Switch or a host computer.
z
LED Indicators:
There are 4 LAN LEDs on the rear panel. They are
described as the following table:
LED Name
Color
LED Function
100M
Green
Steady on:
Ethernet Speed = 100Mbps
Off:
Ethernet Speed = 10Mbps
Act
Green
Blinking:
Transferring Ethernet Data
Off:
No Data Transferring on Ethernet
Conn
Green
Blinking:
When the unit is loading firmware
Steady On:
The firmware load completed
and ready to connect Ethernet
FDX
Green When On, indicates the Ethernet Operates
in the Full Duplex Mode
1.
Use static electricity discharge precautions.
Remove possible static discharge potential from any objects that
the Adapter may come in contact with before installation. This
can be accomplished by touching a bare metal chassis rail after
you have turned off the power.
2.
Attached the DC power source:
there are 2 connectors can be
added the power to the unit. One is the DC Jack (by the AC /DC
Adapter) and the other is the 2-pin terminal blocks.
3.
Connecting LAN cable:
Use a standard straight-through Ethernet
cable to connect to a Hub or Switch. If you connect the USB
Server to your computer’s Ethernet port instead, you don’t need
to change to a cross-over type cable since the Adapter provides
auto cross-over feature.
4.
Connect the USB Server’s USB ports to your USB devices.
3. Hardware Installation
