2.1
MOUNTING
HANGING
UPRIGHT
The LED PAR can be mounted in an upright or
sitting position using the supporting brackets.
The LED PAR can be mounted in a hanging position using the
supporting bracket. The bracket should be secured to the
mounting truss or structure using a standard mounting clamp.
Please note that when hanging the unit a safety cable should
also be used.
@ 220V: 40 units may be connected in series
@120V: 20 units may be connected in series
The LED MODULE can be mounted at any angle and in any
position. It is possible to further adjust the angle of the LED
MODULE using the two adjustment knobs located on the side of
the fixture.
2.2
POWER CONNECTIONS
5
2 INSTALLATION
Note:
As this fixture's DMX signal cable connection had been changed to
Parallel connection, so if over 30 units to be connected, then a DMX signal
amplifier is needed.
2
INSTALLATION
2009.12.9
12
3 DISPLAY PANEL OPERATION
2009.12.9
3.12
SAVE
Only the main menu and the Auto-programs submenu can be protected
Repower the unit, it will back to the main menu
3.11
PASSWORD
PASSWORD
ON/OFF
MENU
PASSWORD
Enter the
PASSWORD
mode to select whether the access password is on or off.
When the fixture is set as PASS
ON
, after 30 seconds or turn on the fixture next
time, the fixture will need an access password to enter the display menu control.
Note:
The factory access password is
UP
+
DOWN
+
UP
+
DOWN
, then
press
ENTER
to confirm the access.
3.10
SETTINGS
MENU
ID
Reset to Factory?
Up load custom?
Up load custom?
Choose
ON
/
OFF
to open or close ID
This function will reset all setting to the original factory setting
Select
to upload the custom programs from the current
MASTER unit to the SLAVE units
COLOR
is f ora ctivate/unactivate t hec olorc alibrationf unctions. When
[
UC
] is selected, the RGB output are adjusted to a standard preset universal
color which balances fixtures from different generations..
The factory default setting is [
UC
] on.
SETTINGS
ID
ON/OFF
Reset to
Factory?
Up load
costom?
COLOR
UC
OFF
