65
The procedure for running the
S
TICK
program is as follows:
1
Connect the supplied cable (Part no. 97945) to the KT-9
computer port located on the bottom panel (covering the
battery compartment).
2
Connect the other end of the cable to the
COM
1:
serial port
of your computer. Please note that the cable has a DB-9
connector. If your computer has the older 25-pin ports you
will either need a DB-9 to DB-25 adaptor or ask
EXPLO-
RANIUM
for a special DB-25 version of the connector cable.
3
Turn on the KT-9.
4
Select either the
N
O
-P
IN
(
nP
) or
C
ORE
(
Cor
) measuring
modes.
5
Erase all old data in the KT-9’s memory.
6
Run the
S
TICK
program on your computer. A typical session
follows and is shown in Figure 21:
Figure 21
Sample session using the S
TICK
program
a)
You will be reminded to connect the KT-9 to the com-
puter, turn on the KT-9, select either the
N
O
-P
IN
or
C
ORE
G:\XPLRANUM>scan7
*** SCAN MODE OF KAPPAMETER KT-9 ***
CONNECT KT-9 TO COM1 OF PC-COMPUTER
SWITCH KT-9 ON
SELECT MEASURING MODE ’nP’ OR ’Cor’
ERASE ALL DATA FROM MEMORY OF KT-9 - press ENTER on PC
*** KT-9 READY ***
Enter name of file DEV:FILENAME.EXT mydata.dat
File mydata.dat opened for input
Enter HEADER of measurement FIRST Measurement
65
The procedure for running the
S
TICK
program is as follows:
1
Connect the supplied cable (Part no. 97945) to the KT-9
computer port located on the bottom panel (covering the
battery compartment).
2
Connect the other end of the cable to the
COM
1:
serial port
of your computer. Please note that the cable has a DB-9
connector. If your computer has the older 25-pin ports you
will either need a DB-9 to DB-25 adaptor or ask
EXPLO-
RANIUM
for a special DB-25 version of the connector cable.
3
Turn on the KT-9.
4
Select either the
N
O
-P
IN
(
nP
) or
C
ORE
(
Cor
) measuring
modes.
5
Erase all old data in the KT-9’s memory.
6
Run the
S
TICK
program on your computer. A typical session
follows and is shown in Figure 21:
Figure 21
Sample session using the S
TICK
program
a)
You will be reminded to connect the KT-9 to the com-
puter, turn on the KT-9, select either the
N
O
-P
IN
or
C
ORE
G:\XPLRANUM>scan7
*** SCAN MODE OF KAPPAMETER KT-9 ***
CONNECT KT-9 TO COM1 OF PC-COMPUTER
SWITCH KT-9 ON
SELECT MEASURING MODE ’nP’ OR ’Cor’
ERASE ALL DATA FROM MEMORY OF KT-9 - press ENTER on PC
*** KT-9 READY ***
Enter name of file DEV:FILENAME.EXT mydata.dat
File mydata.dat opened for input
Enter HEADER of measurement FIRST Measurement