72
SunSDR2 PRO User Manual
© 2018 Expert Electronics
ExpertSDR2 SOFTWARE DESCRIPTION
·
Enable CAT – Checkbox to enable control of the transceiver via the CAT-system.
·
Port name – COM-port number.
·
Parit y – Parity.
·
Dat a – Amount of data in bits.
·
St op bit – Amount of stop bits.
·
Baud rat e – Port speed.
·
PTT line – COM-port line to activate the TX mode.
·
Key line - COM-port line for the CW mode.
·
DTR/RTS – COM-port line for the PTT mode.
·
Enable SubRX cont rol (FR command) - Checkbox to enable control of the sub-receiver
via the CAT-system.
Set the Enable SubRX cont rol (FR command) checkbox to enable the control of the sub-
receiver via the CAT-system.
·
Ant enna swit ch cont rol – Checkbox to enable control of the antenna switch via the CAT-
system.
Set the Ant enna swit ch cont rol checkbox to enable the control of the antenna switch via
the CAT-system. Useful for the Ham Radio Deluxe software.
·
G lobal volume cont rol - When this checkbox is enabled, you control the global volume with
the Volume slider, on the top of the software window, from the CAT-system. Recommended
when you use one RX or VFO A only, SubRX is disabled.
·
Enable PTT – Checkbox to enable control of the TX mode via the COM-port.
Set the Enable PTT checkbox to enable the control of the TX mode via the COM-port.
Summary of Contents for SunSDR2 Pro
Page 2: ......
