26
MANUGENETOP3xx - Version 2.00
© 2018 EXOR International S.p.A. - Subject to change without notice
13.1 Touchscreen Calibration - “Go to Calibration Mode”
Touchscreen calibration may be required to restore proper operation of the touchscreen interface.
13.1.1
Standard Calibration
1.
Recall Configuration Mode
2.
Touch and hold CLEAR key on the screen until TOUCH SCREEN CALIBRATION message
appears, then follow the instructions on page (reported also below)
3.
touch and hold the x symbol in the right upper corner until it will move to the low left corner of
the screen
4.
touch and hold the x symbol in the low left corner
5.
touch the key
6.
touch the key
until the indication to touch the Enter key will be displayed on the screen
7.
touch the Enter key
13.1.2
Emergency Calibration
The Emergency calibration procedure should be used in all cases when it would result not possible to
go to calibration using the standard procedure.
1.
Switch off the unit
2.
turn on the unit
3.
tap in the middle of the touchscreen with a frequency of about half a second until the operator
panel will enter the Calibration Mode
4.
perform the standard calibration procedure.
13.2 “Go to Configuration Mode”
In the case it might prove impossible to switch the operator panel to Configuration Mode due to
problems in the start-up phase, follow the procedure below:
1.
Switch off the unit
2.
Touch in the middle of the left side of the display screen with the left hand
3.
Switch on the operator panel and tap with the right hand in the middle of the right side of the
display screen with a period of about half a second.
4.
Continue until the screen will show Configuration Mode
13.3 Safe Mode
Panel “safe” mode allows some specific and special operations to be performed on the unit.
Under some circumstances “safe” mode is required to reset the panel contrast adjustment parameters.
The panel safe mode activation is similar to the emergency procedure that activates Configuration
Mode at start-up.
1.
Switch off the unit
2.
Divide the screen in two parts with a horizontal imaginary line; press and hold one finger on the
upper part of the display screen.
3.
Switch on the operator panel and tap in the bottom part of the display screen with a period of
about half a second
4.
The panel will remain with black screen and system leds blinking
13 Special Modes: Calibration, C
onfiguration
and Safe Mode
