15
MANUGENETOP3xx - Version 2.00
© 2018 EXOR International S.p.A. - Subject to change without notice
The equipment is not intended for continuous exposure to direct sunlight.
This might accelerate the aging process of the front panel film.
The equipment is not intended for installation in contact with corrosive chemical compounds. Check the
resistance of the front panel film to a specific compound before installation.
Do not use tools of any kind (screwdrivers, etc.) to operate the keyboard of the panel or the touch screen.
In order to meet the front panel protection classifications, proper installation procedure must be followed:
•
the borders of the cutout must be flat
• screw up each fixing screw until the plastic bezel corner get in contact with the panel.
•
the cutout for the panel must be of the dimensions indicated in this manual.
The IP65 is guaranteed only if:
• max deviation from the plane surface to the cut-out:
O
0.5mm
• thickness of the case where is mounted the equipment: from 1,5mm to 6mm
• max surface roughness where the gasket is applied:
O
120 um
Applying the rectangular gasket
The gasket should be applied on the rear of the frame.
Fig. 4.1
A.
Gasket
B.
Installation cut-out
4 Technical Data
4.2 Installation Environment
