- 32 -
FIGURE 12
SEAT SWITCH ADJUSTMENT
6.2.12 Electric Clutch Adjustment
a)
Stop engine, wait for all moving parts to stop, and remove key.
b)
Engage parking brake.
c)
Place .015-.021 inch feeler gauge through each of the three clutch gap
holes. If gap exceeds this range, tighten the three adjusting nuts (c) until
the proper gap is obtained (See Figure 13). The three clutch gap holes are
located at the “nut side” of the adjusting bolts. The adjusting bolts can be
identified by the springs surrounding each bolt.
FIGURE 13
ELECTRIC CLUTCH ADJUSTMENT
6.2.13 Steering Chain Adjustment
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Position the steering handle bar so that it points the unit straight forward (the
rear steering wheel should be in line with the rider main frame channel).
c) Check to see if the chains are loose.
d) To take up slack in the chains, loosen the rear jam nuts connecting the
eyebolts to cross link bars, then equally tighten each forward jam nut until
slack is taken up. Retighten the forward jam nuts onto the links.
e) If the unit tends to turn left when handle bar is positioned for straight forward
travel, adjust by shortening the right hand link (threading jam nuts
closer
to
“eye” end of the eyebolt) and lengthening the left hand link (threading jam
nuts
away
from the “eye” end of the eyebolt) an equal amount. Re check
chain tension.
f)
If the unit tends to turn right when handle bar is positioned for straight
forward travel, reverse procedure as stated in paragraph “d” above.
6.2.14 Throttle Control Adjustment
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Loosen the cable clamp on the engine and position the throttle control at the
control console within 1/4” (6mm) from the upper end of the slot. Pull on
cable assembly at lower end, where it attached to the engine, until the
throttle control arm contacts the stop screw. Secure cable with cable clamp.
( c )
Summary of Contents for Turf ranger
Page 1: ......
Page 43: ... 38 ...
