- 28 -
FIGURE 6
CUTTING HEIGHT ADJUSTMENT
ANTI-SCALP ROLLER ADJUSTMENT
c)
Adjust anti-scalp rollers for Normal Operating Conditions. Place rollers in
one of the positions shown in Figure 6. Rollers will maintain 3/4 in. (19 mm)
clearance to the ground to minimize gouging and roller wear or damage.
For maximum deck flotation,
place rollers one hole position lower. Rollers
should maintain 1/4 in. (6.4 mm) clearance to ground.
Do
Not
adjust rollers
to support the deck. Be sure roller bolts and nuts are installed with the
spring disc washer between head of bolt and mounting bracket.
d)
When operating in extremely rough conditions it may be necessary to
position the anti-scalp rollers one or two holes higher than described in "b"
to prevent damage to the rollers and/or bolt failure (See Figure 6).
NOTE:
When anti-scalp rollers are placed in these positions, reduced deck
flotation will result.
6.2.2
Transmission drive belt tension adjustment: No adjustment necessary.
6.2.3
Mower deck drive belt: No adjustment necessary.
6.2.4
Blade drive belt tension. No adjustment necessary.
6.2.5
Neutral Centering Adjustment
a)
The Neutral Centering Device adjustment should be made with the engine
running at full throttle. First raise and securely block up the frame so that
the drive wheels can rotate freely without contacting the ground.
WARNING
POTENTIAL HAZARD
♦
Engine must be running and drive wheels must be
turning so motion control adjustment can be
performed.
WHAT CAN HAPPEN
♦
Contact with moving parts or hot surfaces may cause
personal injury.
HOW TO AVOID THE HAZARD
♦
Keep fingers, hands, and clothing clear of rotating
components and hot surfaces.
Summary of Contents for Turf ranger
Page 1: ......
Page 43: ... 38 ...
