Operation
Push the lever forward and down to disengage the
brake.
The unit must be tied down and brake engaged when
transporting.
Ignition Switch
Located on right console (see Figure 6).
The ignition switch is used to start and stop the
engine. The switch has three positions “OFF”, “ON”
and “START”. Insert key into switch and rotate
clockwise to the “ON” position. Rotate clockwise to
the next position to engage the starter (key must be
held against spring pressure in this position). Allow
the key to return to the “on” position immediately
after the engine starts.
Figure 7
1.
Off
3.
Start
2.
On
Note:
Brake must be engaged, motion control
levers out (neutral lock position) and PTO switch
disengaged to start engine. (It is not necessary for the
operator to be in the seat to start the engine.)
Hour Meter
Located on the right console in the message display
(see Figure 6 and Figure 8).
The hour meter records the number of hours that
the engine has run.
Figure 8
1.
LCD Indicators
2.
Low fuel indicator light
3.
Fuel level bar display
4.
Low voltage indicator light
5.
Hour/Voltage display
The hour meter is recording when the decimal point
is flashing in Hour/Voltage display.
Hours are displayed when the key is off or when the
machine is running.
Note:
If the ignition key is turned to the “ON”
position for a few seconds before cranking the engine,
the battery voltage will display in the area where the
hours are normally displayed.
Note:
The LCD indicators appear when each control
meets the “safe to start” mode (e.g. the indicator
turns on when the operator is in the seat.)
Fuel Shut-Off Valve
Located behind and below the seat.
The fuel shut-off valve is used to shut off the fuel
when the machine will not be used for a few days,
during transport to and from the jobsite, and when
parked inside a building.
Align valve handle with the fuel line to open. Rotate
90° to close.
Fuel Gauge
Located on the right console in the message display
(see Figure 6 and Figure 8).
The fuel level is shown on a bar display. The indicator
light appears when the fuel level is low (approximately
one gallon remaining in the tank).
22
Summary of Contents for LAZER Z LZX680KC486
