Maintenance
Figure 27
1.
Foot lever
3.
Transport lock
2.
Height of cut pin
6. Insert the height adjustment pin into the 3 inch
(7.6 cm) cutting height location.
7. Release the transport lock and allow the deck to
lower to the cutting height.
8. Raise the discharge deflector.
9. Measure from the level surface to the front tip of
the center blade. The measurement should read
3 inches (7.6 cm).
Note:
In most conditions, the back blade tip
should be adjusted 1/4 inch (6.4 mm) higher than
the front.
Figure 28
1.
3 1/4 inches (8.3 cm)
4.
3 inches (7.6 cm)
2.
Back blade tip
5.
Level surface
3.
Front blade tip
10. Loosen the jam nuts on the top of each deck
link. Fine tune the adjuster on the front deck
lift assembly by turning it to get 3 inch (7.6 cm)
height (see Figure 29).
To increase the height, turn the adjuster clockwise;
to decrease, turn counterclockwise.
Figure 29
1.
Adjuster link
3.
Adjuster
2.
Jam nut
11. The back tip of the blade should measure 3
1/4 inches (8.3 cm). Fine tune rear adjusters as
required.
41
Summary of Contents for LAZER Z LZX680KC486
