![background image](http://html1.mh-extra.com/html/exibel/36-4279/36-4279_manual_2450217006.webp)
EN
G
LI
SH
6
Screw
Battery Compartment Cover
Control
Battery Compartment
6. Getting started
1. Turn the inspection camera over to remove
the battery cover on the underside.
2. Loosen the screw and remove
the battery cover.
3. Take out the battery compartment and
insert AA/LR6-batteries (not included) as
indicated by the markings in the battery
compartment.
Attention!
Use only alkaline 1.5 V batteries. Do not use rechargeable 1.2 V batteries
because the voltage is too low and their lifetime is too short.
4. Replace the battery compartment, making sure it is correctly positioned with the
broader edge facing the display.
5. Put the battery cover back on and position it firmly in place.
Insert SD/MMC memory card
The inspection camera can save still pictures and/or video clips on the SD memory card.
The number of pictures that can be stored depends on the size of the memory card.
Warning!
Position the memory card correctly and insert it carefully (it fits in only one way). Do not
insert or remove memory card when camera is on.
1. Switch off inspection camera.
2. Open the rubber cover.
3. Turn the memory as shown in the Fig. and
apply pressure to it carefully until it fits firmly
into place.
Remove the memory card in this way
: Apply
slight pressure to loosen it and then pull it out.
When the memory card is full the display shows
“CARD FULL”. The memory must then be replaced,
deleted or formatted.