12
ASSEMBLY
Step 3
Note:
The parts are labeled with R and L decals to indicate the left and right sides. The left and
right side are labeled as if you are on the inversion table.
3A. Installing the Front Support Post
Align the
Front Support Post (4)
and two
Metal Plates (5)
with both the
Left & Right Front
Posts (3) & (2).
Attach with four
Hex Bolts (47)
, four
Flat Washers (59),
and
four
Nylon Nuts
(61). DO NOT
fully tighten the hardware until instructed to do so in
STEP 4
.
DO NOT fully tighten Socket Hex Bolts (47) at this time.
3B.
NOW
fully tighten
the four
Socket Hex Bolts (46)
using the
6mm Allen Wrench
provided.
3C.
Attach two
Rubber Pads (43)
onto the
Front Support Post (4).
3D.
install a
Foot Caps (41)
onto each end of the
Foot Bars (1).
(59) Flat Washers
4 PCS
(61) Nylon Nut
4 PCS
Hardware:
(47) Hex Bolt
4 PCS
Tools:
13,17mm Wrench
2PCS
6mm Allen Wrench
1PC
