44-PIECE AIR TOOL KIT
B2
32
31
D2
F2
E2
AIR HAMMER
D3
33
NOTE:
This tool features a power
regulator valve. Rotate the air regulator
(F2) until desired output is achieved. The
settings 1, 2, 3, 4 are only for reference
and do not denote a specific power
output. “Setting 1” (one-line symbol) is
the least amount of power while
“Setting 4” (four-line symbol) is the most
amount of power. Rotate the air
regulator (F2) until the desired setting is
lined up with the small steel ball (D2) on
air inlet (E2). (See Figure 31)
NOTE:
This tool features an exhaust
deflector (B2) 9 which can be rotated to
any position to direct air away from
workpiece or operator. (See Figure 32)
1. Hold the tool firmly with both hands. Bring the
tool towards the workpiece at an angle of
60-70 degrees approximately.
2. Press the trigger (D3) slowly with the chisel in
light contact with the workpiece. (See Figure 33)
3. Slowly move the chisel across the workpiece
surface.
NOTE:
When removing scale, rust or
other contaminants, you only need to
apply a light force on the tool.
NOTE:
Keep the chisel contacting the workpiece while you are releasing
the trigger to stop operation. The tool may impact briefly after the trigger
is released.
21
