7
Other Remote Start Features
It is typically recommended that vehicles equipped with turbocharged engines
allow the engine to idle after driving to cool the turbocharger� When this Installer
Programmable Feature is enabled, the system will automatically keep the engine
running as follows:
• With the engine running, hold the brake pedal and engage the parking brake.
When the brake pedal is released, the system will keep the engine running for the
programmed time (1, 2, or 3 minutes), and then automatically turn it off�
• The system may be locked while the engine is running. Turbo Timer can be
prevented from engaging, or “bypassed” if desired, by turning the engine off before
engaging the parking brake, or if it’s already engaged, step on the brake pedal to
turn the engine off�
LOw BaTTeRy aUTOMaTIC STaRTIng
TURBO TIMeR FeaTURe
PIT-STOP FeaTURe
This feature allows you to leave your engine running for making quick errands. To
use this feature, have the engine running normally from the ignition switch and your
foot off the brake pedal. Press the Valet Switch twice; the parking lights will flash
and the horn chirps 5 times� Turn the key off and the engine will remain running for
the programmed run time�
ManUaL TRanSMISSIOn STaRTIng
Remote starting with a manual transmission requires a different installation
method and installer feature #12 must be turned on� Also, a setup procedure that
ensures the transmission was left in neutral must be performed each time you leave
your vehicle and intend to use remote start later� Perform these steps:
1) With the engine running, hold the brake pedal, apply the parking brake, then
release the brake pedal�
2) Use the transmitter as if you were activating remote start (default: press START
twice). The status light will start to flash slow.
3) Turn off the ignition key and exit the vehicle�
This feature will automatically start the engine if the vehicle battery drops below
11 volts or the interior temperature drop to 15 (or 32) degrees fahrenheit� You must
activate these features each time you park your car to use them� They can be acti-
vated one of two ways:
Method 1 - Valet Switch
• Turn the ignition switch “on”, then “off” (engine not running), and within 7 seconds
press the valet switch twice� If there is a 2 second delay without additional valet
button presses, the horn will honk 3 times activating low voltage start mode�
• To activate low temp starting, enter low voltage start mode as described above
but, before the horn honks, press the valet switch 1 time (15 degrees) or 2 times (32
degrees) within 5 seconds. The horn will honk to confirm your selection.
Method 2 - with The Controller
• Within 5 seconds of pressing LOCK, press the START button. You will get one
chirp to indicate successful activation of this feature�
nOTe:
This feature will operate a maximum of once every two hours until the igni-
tion key is turned “ON”�
