10
Other Remote Start Features
It is typically recommended that vehicles equipped with turbocharged engines allow
the engine to idle for after driving to cool the turbocharger� When this Installer Pro-
grammable Feature (#10) is enabled, the system will automatically keep the engine
running as follows:
• With the engine running, hold the brake pedal and engage the parking
brake� When the brake pedal is released, the system will keep the engine running for
the programmed time (1, 2, or 3 minutes), and then automatically turn it off�
• The system may be locked while the engine is running� Turbo Timer can be
prevented from engaging, or “bypassed” if desired, by turning the engine off before
engaging the parking brake, or if it’s already engaged, step on the brake pedal to turn
the engine off�
TURBO TIMER FEATURE
LOW VOLTAGE & HIGH/LOW TEMP AUTOMATIC STARTING
This feature will automatically start the engine if the vehicle battery drops below
11�5 volts or the interior temperature goes above or below the pre-programmed
threshold�
Programming The Low Temperature Auto Start Threshold:
• Turn the ignition switch “on”, then “off” (engine not running), and within 5 seconds
press the valet switch twice� The siren will chirp 3 times, within 5 seconds press the
valet switch equal to the desired low temperature remote start threshold�
1 press = 0 degrees F - 1 chirp confirmation
2 presses = 15 degrees F - 2 chirps confirmation
3 presses = 32 degrees F - 3 chirps confirmation
Programming The High Temperature Auto Start Threshold:
• Turn the ignition switch “on”, then “off” (engine not running), and within 5 seconds
press the valet switch three times� The siren will chirp 4 times, within 5 seconds
press the valet switch equal to the desired high temperature remote start threshold�
1 press = 75 degrees F - 1 chirp confirmation
2 presses = 90 degrees F - 2 chirps confirmation
3 presses = 105 degrees F - 3 chirps confirmation
4 presses = 120 degrees F - 4 chirps confirmation
Activation Using The Valet Switch
• Turn the ignition switch “on”, then “off” (engine not running), and within 5 seconds
press the valet switch twice� After a 2 second delay without additional valet button
presses, the siren will chirp 3 times activating low battery & low/high temp auto start�
Activation Using The Controller
• Within 5 seconds, press UNLOCK, LOCK, START� The siren/horn will chirp to
confirm.
These features will operate once every two hours until the ignition key is turned “ON”�
• You must activate this features each time you park your car to use them�
