Controller & Transmitter Functions (cont’d)
CHANNEL 3:
Press and hold the TRUNK & START buttons for 2
seconds
• YOUR SYSTEM WILL ACTIVATE THE CH 3 OUTPUT
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL FLASH THE START &
TRUNK LED’S 3 TIMES
CHANNEL 4:
Press and hold the LOCK & TRUNK buttons for 2
seconds
• YOUR SYSTEM WILL ACTIVATE THE CHANNEL 4
OUTPUT
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL FLASH THE LOCK
& TRUNK LED’S 4 TIMES
• Run Time Extender
: Press the START button one time during remote start to
restart the engine run timer The timer will restart
NOTE: This can only be used once per remote start cycle. The controller will also give you “run
time expiration warning” (2 beeps) 1 minute before the remote start cycle ends.
• If you decide not to drive your vehicle, you can turn off the remote start using the
same method to turn it on (Default = press START twice in 5 seconds)
NOTE: If user feature #8 is programmed for 1 press, the 1st press = Run Time Extender so an
additional press is required.
• Upon entering the vehicle during remote start mode, turn the ignition key to the
“ON/RUN” position (
NOT START!!
) When you press the brake pedal, the remote
start will turn off allowing the ignition key to take over
CHANNEL 5:
Press and hold the UNLOCK & START buttons for 3
seconds
• YOUR SYSTEM WILL ACTIVATE THE CHANNEL 5
OUTPUT
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL FLASH THE
UNLOCK & START LED’S 5 TIMES
5
Summary of Contents for AL-1775-3DB
Page 14: ...BLANK PAGE 13...
Page 25: ...Back Cover Color cover is in a separate file 24...
