EXCALIBUR CHLOROSOFT
WATER SOFTENER/FILTER
INSTALLATION MANUAL
GENERAL WATER SOFTENER/FILTER
INSTALLATION PROCEDURES
The Water Softener/Filter control valve, fittings and/or bypass Water
Softener/Filter valve are designed to accommodate minor plumbing
misalignments that may occur during the Water Softener/Filter
installation. Do Not use Vaseline, oils or other hydrocarbon lubricants
when installing your Chlorosoft Water Softener/Filter or spray silicone
anywhere. A silicone lubricant may be used when installing your
Chlorosoft Water Softener/Filter on black o-rings but is not necessary.
Avoid any type of lubricants including silicone when installing your
Chlorosoft Water Softener/Filter on red or clear lip seals.
Do not use pipe dope or other sealants on the Water Softener/Filter
threads. Teflon tape must be used on the Water Softener/Filter
threads such as the 1 inch NPT elbow, the ¼ inch NPT connection,
and the Water Softener/Filter drain line connection. The nuts and
caps of the Chlorosoft Water Softener/Filter are designed to be
unscrewed or tightened by hand or with the special plastic Water
Softener/Filter service wrench part number V3193. If necessary,
pliers can be used to unscrew the Chlorosoft Water Softener/Filter
