nut or cap. No not use a pipe wrench to tighten or loosen the
Chlorosoft Water Softener/Filter nuts or caps. Do not place
screwdriver in slots on caps and/or tap with a hammer as this could
damage the Chlorosoft Water Softener/Filter
WATER SOFTENER/FILTER/FILTER INSTALLATION
SITE REQUIRMENTS
•
Water pressure 20 – 125
psi
•
Current draw is 0.25 amps
•
Water temperature 5 to
30°C or 40 to 100°F
•
A 15 foot power cord is
furnished
•
The Water Softener/Filter
tank should be on a firm
level surface
•
The plug-in transformer is
for dry location only
•
Electrical use of 115/120
volt 60 Hz uninterrupted
outlet
•
Batteries are not used
1.
The distance between the Chlorosoft Water Softener/Filter
and the water drain should be as short as possible. When
installing your Chlorosoft Water Softener/Filter all plumbing
must be done in accordance with local plumbing codes. The
Water Softener/Filter must not have a piping header that
exceeds 3 meters (10 feet).
2.
Since Water Softener/Filter salt must be used periodically
and be added to the Water Softener/Filter, the brine tank
should be located where it is easily accessible.
