13 - DIMMING CURVES
14 - TRIGGER
The trigger input is a dry-contact between the two pins of the terminal block connector.
Do
not apply any voltage on this input
. Dry contact trigger input should be used with passive
switches, in respect with the common GND equipotential reference.
- In DMX & CRMX mode, when the contact is closed, the DMX/CRMX commands are
by-passed and the value set on the 16-position rotary switch is applied to the output.
- In manual mode, when the contact is closed, the output is turn off (black out).
15 - INSTALLATION & CABLING
LEDMASTER STUDIO 1 enclosure is designed to be mounted onto a standard DIN rail 35mm
width (EN 60715), but wall mounted is another option. Use the embedded plastic hook to
attach or detach from the rail. This device is delivered with all required terminal block plugs.
16 - FACTORY RESET
To factory reset the device, press and hold the RESET push button during 10secs. The device
will flash memory to default factory settings and restart.
Note: Hardware settings on the DIP switch (SETTINGS) and rotary switches (DMX ADDRESS,
MANUAL DIMMING) will be automatically restored.
17 - DRAWINGS
64.90mm
108mm
91mm
98mm
170.65mm
142.30mm
Note 1: the CUSTOM dimming curve
has been optimized for 18,5W 12V
AR111 spot at 32kHz
Note 2: dimming curves correspond
to the 8 bits mode (0-255), but 16 bits
mode is very similar
