Protocols
DMX512-A & RDM (ANSI E.1.20) - RDM manufacturer ID: “0084h”
Universe
1
DMX frame rate
0,8-830Hz
DMX input/output
1x DMX input/Passthrough, 2x 5.08mm terminal block (green), 3 positions
DMX options
DMX resolution: 8 bits or 16 bits
DMX fail: Hold, Black, Full or Manual setting
DMX fading: On/Off
DMX CHARTS:
Addr
Addr+1
Addr+2
DMX - 8bits
Output brightness
(0% to 100%)
-
-
DMX - 16bits
Output brightness
(0% to 100%, MSB/Coarse dimming)
Output Brightness
(LSB/Fine dimming)
-
DMX - 8bits + Fading
Output brightness
(0% to 100%)
Fading
(0s to 5s)
-
DMX - Fading
Output brightness
(0% to 100%, Coarse dimming)
Output Brightness
(Fine dimming)
Fading (0s to 5s)
10 - RDM
To enable the RDM control, the device must be set in DMX or CRMX mode (S1-S2
= “00” or “10”) and
the DMX address must be set to “000”
.
When the DMX address “000” is selected, DMX modes (resolution, fading) can be
changed from RDM controller. In that case, values sets on the DIP switch settings
do not necessarily correspond to the current operating mode.
The RDM features can be used on both wired DMX and wireless CRMX.
- RDM manufacturer identifier: «
0084h
».
- RDM labels: ‘‘LEDMASTER STUDIO 1 DMX’’ & ‘‘LEDMASTER STUDIO 1 CRMX’’
- RDM sensors: input voltage & CRMX signal reception (for CRMX versions only)
The device supports the following RDM PIDs:
DISC_UNIQUE_BRANCH
DISC_MUTE
DISC_UN_MUTE
SUPPORTED_PARAMETERS
DEVICE_INFO
FACTORY_DEFAULTS
SOFTWARE_VERSION_LABEL
DMX_START_ADDRESS
IDENTIFY_DEVICE
DEVICE_MODEL_DESCRIPTION
MANUFACTURER_LABEL
SENSOR_DEFINITION
DEVICE_LABEL
DMX_PERSONALITY
DMX_PERSONALITY_DESCRIPTION
SLOT_INFO
SLOT_DESCRIPTION
SENSOR_VALUE
11 - CRMX RADIO INTERFACE
Standard / Technology
CRMX by LumenRadio™
Frequency
2.402 ~ 2.480 GHz
Antenna
Swivel whip omnidirectional, 2.4GHz 2.0dBi, SMA (SMA-F onboard, SMA-M on antenna)
RF Output
20 dBm (100mW) - ETSI compliant
RF Modulation
GFSK
End to end latency
< 5ms
Range
Up to 300m (depending on the transmitter and the environment)
Interface
3x green LEDs for radio signal level, 1x pushbutton (hold 3s to unlink from transmitter)
