LEDMASTER STUDIO 1 embeds a radio CRMX receiver, RDM compliant, based on
LumenRadio™ technology, enabling to receive a single wireless DMX universe. To
enable the CRMX feature, the device must be set in CRMX mode (S1-S2 = “10”).
Antenna orientation should be optimized according to the expected radio perfor-
mances and the LEDMASTER STUDIO 1 environment.
Link procedure:
- Make sure that both devices are powered, and dimmer is unlinked.
- Start the linking procedure on the transmitter.
- During the linking procedure (~10s), any unlinked receiver in range will
automatically link to the transmitter.
If LEDMASTER STUDIO 1 is linked to a transmitter, the blue Status LED
indicator turns on (even if the transmitter is off).
- During the linking procedure, the DMX signal is not transmitted.
Unlink procedure:
- Long press (>3s) the pushbutton on the dimmer until the status indicator
turns off. You can also unlink all linked receivers from the transmitter.
Signal level indicators:
- Blinking = no signal
- 1 LED = poor reception
- 2 LEDs = correct reception
- 3 LEDs = excellent reception
Status indicator:
- Off: Device is not linked to any transmitter
- Flashing: off 100ms / on 100ms: Device is linked but no active radio link
- Flashing: off 900ms / on 100ms: Device is linked, no DMX present
- On: Device is linked to a transmitter, DMX data present
Once everything is set up, the LEDMASTER STUDIO 1 works the same way as it does
for wired DMX: the address and mode are the same.
12 - MANUAL DIMMING
To enable the MANUAL DIMMING feature, the device must be set in manual mode
(S1-S2 = “01”). In this mode, the output brightness can be manually controlled
from the 16 positions rotary switch. Use a small flat screwdriver to select the value.
The first 10 positions (0 to 9) allows to adjust with 5% steps, the last 6 positions (A
to F) allows to adjust with 10% steps.
0
0% (Off)
5
25%
A
50%
1
5%
6
30%
B
60%
2
10%
7
35%
C
70%
3
15%
8
40%
D
80%
4
20%
9
45%
E
90%
F
100% (Full On)
