NL
FR
EN
42
FOR MAXIMUM APPLIANCE EFFICIENCY
Fig. 21
OPERATIONS TO CARRY OUT AT THE START AND END OF PERIODS OF USE
VERIFICATIONS AT START OF PERIOD OF USE
Make sure that the power cable and plug are not damaged and that the installation is
correctly earthed. Follow the installation instructions carefully.
OPERATIONS AT END OF PERIOD OF USE
To entirely empty the internal circuit of the water it contains, remove the cap (fig. 21).
Let all the water drain into a basin or bowl. When all the water has come out, replace
the cap.
Clean the filter and dry it out completely before reinstalling it.
REMOTE CONTROL
• Point the remote control towards the sensor on the appliance.
• The remote control must not be operated more than 7 metres from the appliance (without any obstacles between the
remote control and the sensor).
• The remote control must be operated with care. Do not let it fall to the ground, do not expose it to sunlight or heat sources.
If the remote control is not working, try removing and then reinstalling its battery.
Plastic film can be pulled
off
The remote control is supplied with a battery already fitted.
To use the remote control, for the first time, gently pull the transparent plastic film out of the battery compartment.
REPLACING THE BATTERY
To replace the battery, carry out the following instructions, using the illustration to help you:
Pin
Cover hole
Battery
1 Insert
remove it.
2 Replace the worn battery with a CR2025 battery.
3 Then correctly replace the lid onto the remote control.
CLEANING AND MAINTENANCE
• Always unplug the appliance before cleaning it.
• Clean the surface of the appliance using a soft cloth, do not use any water.
• If the appliance is very dirty, clean the surface using a damp cloth (add a non-corrosive cleaning product if required.
• Do not use corrosive detergents, corrosive solvents or chemical products.
• Do not use an abrasive sponge, scouring pad or hard brush to clean the appliance.
• Do not immerse the main body of the appliance into water.
• Ensure that the motor and the other electrical components do not come into contact with water.
• If the appliance is not to be used for a long period, pack it away carefully. Store it in a dry and ventilated area where it will
not be affected by dust.
• To avoid
• To ensure
• The
• Step
• Step
• Use
and rinse it several times. The temperature of the water should not be higher than 40°C (104°F). After washing it, leave the
filter
THIS APPLIANCE IS SOLELY DESIGNED FOR DOMESTIC USE
Manual_Snowair7C-9C-9CP-12C-12CP_2021.indd 42
Manual_Snowair7C-9C-9CP-12C-12CP_2021.indd 42
25/01/21 11:33
25/01/21 11:33