NL
FR
EN
40
WATER DRAINAGE METHOD
When there is an excess of condensation water in the unit, the appliance will stop operating and displays
(which means
FULL TANK as mentioned below in the TROUBLESHOOTING section). This indicates that the condensation water needs to be
drained by carrying out the following procedures:
Manual drainage (Fig. 14)
The water must be drained into an area adapted for this purpose.
1. Unplug the unit from the power supply.
2. Place an appropriate recipient close to the drainage cap. (Fig. 14)
3. Remove the drainage cap.
4. The water needs to be drained and collected in a recipient (not supplied).
5. Once the water has been drained, replace the drainage cap firmly.
6. Switch the unit on.
Fig. 14
Continuous drainage (Fig. 15)
When using the air-conditioning unit in dehumidification mode, continuous drainage is recommended
1. Unplug the appliance from the power supply.
2. Remove the drainage cap. While doing this, some water may come out, so make sure you have an appropriate recipient to
collect it in.
3. Connect the 2m drainage pipe (18). See fig. 15.
4. The water can be continuously drained into a drain, a bucket or a sink using the pipe.
5. Switch the appliance on.
Fig. 15
NOTE
Please ensure that no part of the drainage pipe is higher than the drainage outlet and has no kinks in it, otherwise the tank will
not drain correctly. (Fig. 16 and Fig.17).
Middle drainage
When unit running in Dry mode, you can choose the way below to drainage.
1. Unplug the unit from the power source.
2. Remove
water.
3. Connect
4. The
5. Turn on the unit.
A
NOTE
Please be sure that the height of and section of the drain hose should not be higher than that of the drain outlet, or the water
tank may
ADVICE FOR CORRECT USAGE
In order to get the best results from your appliance, please follow these recommendations:
• Close the windows and doors of the room you are trying to cool down (Fig. 18). When installing your appliance on a semi-
permanent basis, it is necessary to leave a door open (gap of at least 1cm) to ensure correct ventilation.
• Protect
cooling the appliance needs to carry out (Fig. 19).
• Never place any objects on the appliance.
• Never block the air intake or outlet (Fig. 20). Make sure the grills are unobstructed.
• Ensure that there is no heat source in the room.
• Never
• Never use the appliance out of doors.
• Ensure
18
Manual_Snowair7C-9C-9CP-12C-12CP_2021.indd 40
Manual_Snowair7C-9C-9CP-12C-12CP_2021.indd 40
25/01/21 11:33
25/01/21 11:33