EWT Clima ML Manual Download Page 20

Page: 20 / 44

ELECTRICAL

WARNING – THIS APPLIANCE MUST BE EARTHED

This heater must be used on an A.C. ~ supply only and the voltage marked on the heater must correspond to the supply voltage.

POSITIONING THE HEATER

&Q\F^XJSXZWJYMFYYMJMJFYJWNXXYTTITSFܪWRQJ[JQGFXJSJFWYTGZYSTYINWJHYQ^ZSIJWSJFYMFXZNYFGQJRFNSXXZUUQ^XTHPJY

Ensure that curtains and furniture are not positioned close to the chosen position.

WARNING: Please ensure the minimum clearance dimensions indicated in Fig.1 are maintained.

ASSEMBLY

<&73.3,9MJMJFYJWRZXYTSQ^GJTUJWFYJI\NYMYMJKJJYXJHZWJQ^ܪYYJIFSINSYMJZUWNLMYUTXNYNTS

3J[JWZXJYMJMJFYJWFXFUTWYFGQJFUUQNFSHJ\NYMTZYYMJKJJYXJHZWJQ^ܪYYJIZXNSLYMJXHWJ\XUWT[NIJI

9TFXXJRGQJQF^YMJMJFYJWTSNYXGFHPFSIWJRT[JYMJY\TKTTYܪ]NSLXHWJ\XXJJ+NL&XXJRGQJYMJKJJYG^UWJXXNSLYMJR

ܪWRQ^NSYTYMJHTS[JHYTWGTI^FXNSINNLYMJKTTYXMTZQIHQNUNSYTUTXNYNTS

8JHZWJZXNSLYMJKTTYܪ]NSLXHWJ\7JYZWSYMJMJFYJWYTYMJZUWNLMYUTXNYNTS

The appliance is now ready for use.

USING THE HEATER

IMPORTANT - OBJECTS OR CLOTHING MUST NOT BE PLACED ON THIS HEATER.

Before using the heater ensure that all warnings and instructions have been carefully read.
To activate the heater, after installation or assembly, simply plug it in.

3TYJ9MJJQJRJSYMFXGJJSHTFYJI\NYMFUWTYJHYN[JܪQR\MNHM\NQQGZWSTKKIZWNSLYMJܪWXYKJ\RNSZYJXTKZXJYMNXRF^

cause a small amount of fuming. This is quite normal – the fumes are non-toxic and will quickly disappear.

<JWJHTRRJSIYMFY^TZTUJSF\NSIT\YT[JSYNQFYJYMJWTTR\MJSZXNSLYMJMJFYJWKTWYMJܪWXYYNRJ

CONTROLS

&QQRTIJQXFWJܪYYJI\NYMFMJFYXJQJHYNTSX\NYHMFSIFYMJWRTXYFYHTSYWTQNL9MJ(QNRF219ZWGTRTIJQMFXF

mains power indicating Neon lens and a boost fan.

Thermostat

The thermostat controls the heat output according to the room temperature.
This ensures that the heater will not produce heat unnecessarily when the room is warm.
To set the temperature you require, gradually turn the thermostat knob clockwise until the desired temperature is reached.
Allow some time between increments for the room temperature to stabilise.
Alternatively to heat a cold room quickly, turn the thermostat knob to the Max position. When the room has reached the
desired temperature, turn the thermostat knob anticlockwise until the thermostat clicks off. The heater will then automatically
maintain this room temperature.

The thermostat also has a frost protection setting marked ‘

’.

This setting is useful in areas such as garages to prevent frost damage. If the thermostat is set to its minimum setting ‘

’, the

heater will cycle ON and OFF to maintain a temperature of approximately 5°C to help protect against frosty conditions.

Heat selection switch

Depending on the model the options available on the control knob may vary, see Fig.4. The following table explains the opera-
tion of each knob position.

Mode

SAFETY FEATURES

This appliance incorporates a number of safety devices.
In addition to the ‘Important Safety Advice’ section your attention is drawn to the following;

8FKJY^4[JWMJFY5WTYJHYNTS

9MJMJFYJWNXܪYYJI\NYMFYMJWRFQHZYTZY\MNHM\NQQX\NYHMTKKYMJMJFYJWXMTZQINYT[JWMJFYKTWFS^WJFXTS.KYMJYMJWRFQHZYTZY

operates, unplug the unit immediately. Allow the heater to cool down completely and remove the cause of the over heating.
Reconnect the power - normal operation should be resumed.

Tilt switch

9MJUWTIZHYNXܪYYJI\NYMFXFKJY^YNQYX\NYHM\MNHM\NQQUWJ[JSYYMJMJFYJWKWTR\TWPNSLNKYMJMJFYJWNXFHHNIJSYFQQ^YNUUJIT[JW

in any direction.

If the heater is tipped over while it is hot, disconnect the power and allow it to cool, then stand the heater back upright.
Reconnect the power - normal operation should be resumed.

Note: The tilt switch mechanism makes a muted rattling noise when the product is moved or tilted, this is not a fault, this noise
is normal.

ADDITIONAL

9ZWGTKFS8JQJHYJIRTIJQX

9MJYZWGTKFSNXZXJIYTGTTXYYMJFNWܫT\FWTZSIYMJWTTR

This circulates the heat better and results in a reduced heat up time and a more even heat distribution.
The turbo fan is turned On and Off using the Control knob.

Important Notes

Although this heater is manufactured to comply with the relevant safety standards, certain types of carpets could become dis
coloured by the temperatures under a portable heater. If you are concerned about this, we recommend that you contact the carpet
manufacturer
Alternatively, stand the heater on a suitable base to shield the carpet – call our Helpline for further advice.

>TZRF^STYNHJXTRJUFWYXTKYMJJQJRJSYFUUJFWNSLYTGJMTYYJWKWTRYNRJYTYNRJGJHFZXJTKYMJ[FWNFGQJFNWܫT\YMWTZLMYMJMJFYJW

This does not cause a safety hazard.
The heat outlet grille may become discoloured with use – this is caused by airborne pollution and is not a fault.

Clima_Manual.indd 20

7/05/21//18 16:09