OS3030
Manual control
9
Manual control
Some of the button actuation sequences are delayed in order to prevent unintended reactions. The
current delay time is shown in the top right in the first line of the LCD.
The programmed rinse phases are switched on and off automatically. Manual operation is only neces-
sary during maintenance work or when checking functions. Therefore, there are no separate buttons
provided. However, the required start/stop functions can be activated by pressing the "STOP" and
"HORN" buttons simultaneously.
Starting
the
"production"
phase
If the system has been fitted with a reservoir, it
is switched on and off via the level contacts. If
it does not have a reservoir or if the reservoir is
not full, the system can be switched on manu-
ally.
Press the "ON" button. The "PRODUCTION"
LED pilot lamp flashes on after 4 seconds. Up
to 3 preliminary stages may be run through
before the actual production process starts.
The remaining program times of production
preliminary stages 1-3 are shown on the top
right off the LCD.
If the production cycle is started from a rinse
phase the "Rinse Stop" phase is shown for 3
seconds first of all.
WARNING! If the "Tank Full" contact is de-
tected by the level switch on a reservoir, the
message "Tank Full" appears in the LCD, and
the production process cannot be started.
If the installation is switched to the Sleep
phase, it will be switched back to automatic
mode by pressing the ON button (for 1 sec-
ond).
Start "Sleep" phase
The installation can be put into sleep mode
from any phase by pressing the OFF button for
1 second. The Sleep phase can be left again
by pressing the ON button for 1 second.
Starting the "rinse after pro-
duction" phase
If the "rinse after production" phase has been
programmed, it can be started by briefly
switching the system off and on again.
The possible stages, 1-3, are displayed in se-
quence in the LCD, together with the time
lapse.
Stopping the "rinse after pro-
duction" phase
If the system is in the "rinse after production"
phase, it can be stopped by pressing the
"OFF" and "HORN" buttons simultaneously.
Starting
the
"rinse
during
standby" phase
If the "rinse during standby" phase has been
programmed, it can be started if the system is
in "standby".
Press the "OFF" and "HORN" buttons simulta-
neously.
The possible stages, 1-3, are displayed in se-
quence in the LCD, together with the time
lapse.
Stopping the "rinse during
standby" phase
If the system is in the "rinse during standby"
phase, it can be stopped by pressing the
"OFF" and "HORN" buttons simultaneously.
ON
OFF
OFF
OFF
OFF
