4
Commissioning
4/5
4.4
Fitting wire feed units
For WELDON and PHOENIX DRIVE 4L wire feed units, the angle section of the A2 holder
plate should be fitted so that it points downwards (fig. 4/7). Otherwise there is a risk of
injuries from crushing when the wire feed units are rotating.
For housing WELDON and PHOENIX DRIVE 4 wire feed units, the angle section of the A2
holder plate should be fitted so that it points upwards (fig. 4/9).
•
Insert the end of the tube package on the wire feed unit through the strain-relief (fig. 4/7) and
lock by turning to the right (fig. 4/8).
Fig. 4/5
Fig. 4/6
4.4.1
Fitting WELDON DRIVE 4L or PHOENIX DRIVE 4L
A2
E1
C2
Fig. 4/7
C2
Fig. 4/8
•
The wire feed unit should be fitted with the retainer located on the base plate on the pin plug
C2 (fig. 4/7 and fig. 4/8).
4.4.2
Fitting WELDON DRIVE 4 or PHOENIX DRIVE 4
A2
Fig. 4/9
Fig. 4/10
•
Position the wire feed unit on the relevant rails A2 (fig. 4/9 and fig. 4/10)
