Copyright - © 2019 eWBM Co., Ltd. All rights reserved
24 | 24
NTEGRATION INSTRUCTIONS
The module complies with Part15.247/RSS‐247.
The modular transmitter is only FCC authorized for the specific rule part(i.e, FCC transmitter rules) listed on
the grant. The host product manufacturer is responsible for compliance to any other FCC rules that apply
to the host not covered by the modular transmitter grant of certification.
The final host / module combination may also need to be evaluated against the FCC Part 15B criteria for
unintentional radiators in order to be properly authorized for operation as a Part 15 digital device.
The module is authorized with trace antenna design type.
And the module is designed to operate with a dipole antenna.
(Connector: SMA reverse / peak gain: 1.85dBi)
The trace antenna design must be performed as specified in the manual. The use of any other antenna or
any changes to the reference trace design are subject to additional testing and authorization through a
Class II permissive change.
The module is a limited single‐modular transmitter that complies with the § 15.212(a) modular
rules which requires the host operating condition as ; The host product should supply the
regulated power of 3.3V DC to module. The power design should be performed as specified in the manual.
The module is limited to installation in mobile or fixed applications. At least 20 cm of separation distance
between the transmitting antenna device and the user's body must be maintained at all times.
The transmitter module must not be co‐located or operating in conjunction with any other
antenna or transmitter except in accordance with FCC multi‐transmitter product procedures.
The OEM integrator will be responsible to satisfy SAR/ RF Exposure requirements, when the
module integrated into the host device.
The module is labeled with its own FCC ID and IC certification. If the FCC ID and IC
Certification Number are not visible when the module is installed inside another device,
then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. In that case, the final end product must be labeled in a
visible area with the following:
"Contains FCC ID: 2ARG9‐ELR100", "Contains IC : 25891‐ELR100"
Host User Manual
The host manual shall include the following regulatory statement; Part 15.19: This device
complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation. Part 15.21: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. The
antenna(s) must be installed such that a minimum separation distance of at least 20 cm is
maintained between the radiator (antenna) and all persons at all times.
Host Product labeling
The module is labeled with its own FCC ID and IC certification. If the FCC ID and IC
Certification Number are not visible when the module is installed inside another device,
then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. In that case, the final end product must be labeled in a
visible area with the following:
"Contains FCC ID: 2ARG9‐ELR100", "Contains IC : 25891‐ELR100"
