Evolve EVECJ, Installation Manual, Page: 7 / 27

Evolve Customer Support available at 856/552-4000, 888/827-2500, from 8:30 Eastern through 6 Eastern time, or fax at 856/552-4001.
Installation Manual – January 2001
Note : Any alterations to listed components will void the manufacturer's warranty. The manufacturer will
not be responsible for any damage or bodily harm caused by alterations in accordance with national or
local electrical codes and manufacturer's specifications.
In accordance with the manufacturer's policy of continual product improvement, the product presented in
this document is subject to change without notice or obligation.
6
P
anels
Panels
Installation Instructions
Inline Connection – Variable Height
(EVPVC)
Parts List :
1 Slotted post with levelling glide
1 Single clamp
1 Variable-height clamp
A Variable-Height Connector is used to connect two panels of differing
heights in a straight run.
!
!
A Variable-Height Connector must match the height of the taller
panel.
1. Remove the panel top caps.
2. Partially attach a same-height slotted post to one end of the
panel to be installed. Do this by engaging the down-hook at the
bottom of the panel (above the raceway channel) over the up-hook on
the slotted post.
Partially attach the slotted post to the taller panel by engaging
the down-hook at the bottom of the panel (above the raceway channel)
over the up-hook on the slotted post.
3. Connect the taller panel to the slotted post by engaging the single
clamp through the slotted post and into the panel liner. Secure the
single clamp by bolting it to the panel using two (2) 1/2" flat head
screws.
4. Partially attach the lower panel by engaging the down-hook at the
bottom of the panel (above the raceway channel) over the up-hook on the
opposite side slotted post.
5. Connect the top of the lower panel to the slotted post by engaging
the variable-height clamp through the slotted post. Rotate the variable-
height clamp down onto the top horizontal tube of the panel. Secure the
variable-height clamp by bolting it to the top of the panel using two (2)
1/2" flat head screws.
6. Reattach the panel top caps.
1
2
3
4
5
6
7