Evolve Customer Support available at 856/552-4000, 888/827-2500, from 8:30 Eastern through 6 Eastern time, or fax at 856/552-4001.
14
Electrical
Installation Instructions
Directional Floor Power Entry
(EVEEFD)
Parts List
:
1 Directional Floor Power Entry
The Floor Power Entry is used to connect the electrical distribution system to
the building power network at a floor level junction box.
!
!
Ensure that all panels are mechanically connected prior to
electrical connection
.
1.
Locate the appropriate connection point on the panel
. The
raceway cover must be removed to allow installation.
2.
Pass the conduit through the opening in the raceway cover
so
that the connector housing is inside the raceway cover next to the
connection point.
3.
Position the Directional Floor Power into the mounting bracket
on the Power Distribution Housing and slide it in toward the
electrical assembly
. Be sure the parts are fully seated to assure
proper electrical connection and the spring clips below the receptacles
are properly engaged for mechanical security.
4.
Replace the raceway cover.
!
!
It is recommended that installation of the electrical harness be
made under the supervision of a licensed electrician in
accordance with applicable codes and regulations. Refer to the
wiring schematic attached to the conduit and shown in this
Installation Manual. Always determine that harness is
electrically connected to only one power supply.
1
E
le
ct
ric
al
Installation Manual – January 2001
Note
: Any alterations to listed components will void the manufacturer's warranty. The manufacturer will
not be responsible for any damage or bodily harm caused by alterations in accordance with national or
local electrical codes and manufacturer's specifications.
In accordance with the manufacturer's policy of continual product improvement, the product presented in
this document is subject to change without notice or obligation.
2
1
3
4