Evolve Customer Support available at 856/552-4000, 888/827-2500, from 8:30 Eastern through 6 Eastern time, or fax at 856/552-4001.
Corner Connections – Equal Height
Two-Way (EVPCP2), Three-Way (EVPCP3), and
Four-Way (EVPCP4) Corner Posts
Parts List
:
1 Aluminum corner post
1, 2, 3 or 4 slotted posts with levelling glide
(attached to aluminum corner post)
1, 2, 3 or 4 single clamps
Appropriate trim
1 Top cap
Corner Posts are used to connect panels of equal height at a corner.
!
!
Always start the installation of panels at a corner
.
1.
Remove the panel top caps
.
2.
Partially attach a slotted post to one end of the panel to be
installed.
Do this by engaging the down-hook at the bottom of the
panel (above the raceway channel) over the up-hook on the slotted
post.
Attach the opposite end of this panel to one face of the Corner
Post
by engaging the down-hook at the bottom of the panel (above the
raceway channel) over the up-hook on the slotted post. (The slotted
post is secured to the face of the Corner Post.)
3.
Connect the top of the Corner Post to the panel
by engaging the
single clamp through the slotted post and into the panel liner. Secure
the single clamp by bolting it to the top of the panel using two (2) quar-
ter 20 1/2" flat head screws.
4.
Repeat the above procedure
to attach the second, third and fourth
panel to the Corner Post.
5.
Press fit the top cap down onto the top of the Corner Post
.
6.
Reattach the panel tops caps
.
Installation Manual – January 2001
Note
: Any alterations to listed components will void the manufacturer's warranty. The manufacturer will
not be responsible for any damage or bodily harm caused by alterations in accordance with national or
local electrical codes and manufacturer's specifications.
In accordance with the manufacturer's policy of continual product improvement, the product presented in
this document is subject to change without notice or obligation.
2
P
anels
Panels
Installation Instructions
1
2
3
6
5
4
7