Evolve Customer Support available at 856/552-4000, 888/827-2500, from 8:30 Eastern through 6 Eastern time, or fax at 856/552-4001.
Installation Manual – January 2001
3
P
anels
Note
: Any alterations to listed components will void the manufacturer's warranty. The manufacturer will
not be responsible for any damage or bodily harm caused by alterations in accordance with national or
local electrical codes and manufacturer's specifications.
In accordance with the manufacturer's policy of continual product improvement, the product presented in
this document is subject to change without notice or obligation.
Panels
Installation Instructions
Corner Connections – Variable Height
Two-Way (EVPVP2), Three-Way (EVPVP3), and
Four-Way (EVPVP4) Corner Posts
Parts List
:
1 Aluminum corner post
1, 2, 3 or 4 slotted posts of varying heights with levelling glide
(attached to aluminum corner post)
1, 2, 3 or 4 single clamps
Appropriate trim
1 Top cap
Variable-Height Corner Posts are used to connect panels of different heights
at a corner.
!
!
Always start the installation of panels at a corner.
1. Remove the panel top caps.
Partially attach a slotted post to one end of the panel to be
installed.
Do this by engaging the down-hook at the bottom of the panel
(above the raceway channel) over the up-hook on the slotted post.
2.
Attach the opposite end of this panel to the corresponding face of
the Variable-Height Corner Post
by engaging the down-hook at the
bottom of the panel (above the raceway channel) over the up-hook on
the slotted post. (The slotted post is secured to the face of the Variable-
Height Corner Post.)
3.
Connect the top of the Variable-Height Corner Post to the panel
by
engaging the single clamp through the slotted post and into the panel
liner. Secure the single clamp by bolting it to the top of the panel using
two (2) 1/2" flat head screws.
4.
Repeat the above procedure
to attach the second, third and fourth
panel to the Variable-Height Corner Post.
5.
Snap the vertical corner trim pieces ("U", "L", and Flat) onto the
corner post
. Start at the top and align corner trim with panel top cap.
Press fit the top cap down onto the top of the Variable-Height
Corner Post
.
6.
Reattach the panel tops caps.
1
2
3
6
5
4
7
8