Evolution Rage 7, Original Instructions Manual

Page: 11 / 16

11 www.evolutionbuild.com
CHARGING INDICATOR
This charger is designed to detect problems
that can sometimes arise with rechargeable
battery packs. The status of the two LED’s
can alert the operator to potential problems.
Please refer to the table below.
RED LED GREEN LED CHARGER OR BATTERY PACK CONDITION
OFF ON Charger connected to power supply
and ready to receive battery pack
ON OFF Battery pack correctly inserted
and charging cycle in progress
OFF FLASHING Battery charging and
at 90% of full charge
OFF ON Steady green LED -
Battery is completely charged
FLASHING FLASHING At the same time - Battery pack
too hot or cold for charging
FLASHING FLASHING Alternatively – Battery pack defective and needs
to be replaced
Note: If battery pack failure is suspected, we
recommend that the operator inserts a new
battery of known quality into the charger to
check that the charger is working correctly.
If the new battery charges correctly, then
the original battery is probably defective and
should be sent for safe recycling. If the new
battery pack displays the same problems as
the original, have the charger tested at an
authorized service centre.
Warning:
When a battery becomes discharged due to
prolonged use or exposure to direct sunlight
or heat, always allow the battery pack to cool
down before recharging. This will allow the
battery to be recharged to its full capacity.
1. INSTALLING OR
REMOVING THE BATTERY PACK
Check that the battery pack is of the
designated type for this machine. We
recommend that the trigger switch is locked
in the OFF position when removing or
inserting the Battery Pack. Refer to section
3 below.
a. Slide the Battery Pack onto the base of the
tools handle. The Battery can only fit one way
round.
b. Firmly slide the Battery Pack fully into the
tools handle to engage the locking tabs. The
electrical connections inside the handle will
be made automatically.
c. To remove the Battery Pack, simply press
the two locking tabs with your finger and
thumb and slide the Battery Pack from the
handle.
2. INSTALLING OR REMOVING A BLADE
Note:
The battery pack must be disconnected
from the machine when installing or removing
the blade.
1. Remove the battery pack.
2. Check that the jigsaw blade is of the
correct type.
3. Pull back on the collet chuck sleeve using
your finger and thumb of one hand. See Fig 2
4. Insert the blade into the chuck fully
ensuring that the blade teeth face forwards.
5. Release the chuck sleeve.
6. Check to ensure the blade is securely
gripped by the chuck.
7. Check to ensure that the back of the blade
has engaged into the groove in the guide
roller. See Fig 3
8. Replace the battery pack.