background image

1

4.0 

SAFETY

4.1 

The equipment mentioned in the manual is specially designed for the filtering and 
recirculation of water in swimming pools.

4.2 

They are designed to work with clean water at temperatures not exceeding 45°C (113°F).

4.3 

The user should make sure that assembly and maintenance tasks are carried out 
by qualified authorised persons and that these persons have first carefully read the 
instructions for service and installation.

4.4 

The installation should be carried out in accordance to the safety instructions of 
swimming pools, especially Standard HD 60364-7-702, and the specific instructions for 
each facility.

4.5 

Follow any general safety rules or guidelines and any safety legislation and directives 
given by local, state or national authorities.

4.6 

Any modification of the pump requires the prior consent of the manufacturer. Original 
replacement parts and accessories authorised by the manufacturer ensure a high 
level of safety. The manufacturer of the pump assumes no liability for the damage and 
injuries caused by unauthorised replacement parts and accessories.

4.7 

During operation, some parts of the pump are subject to dangerous electric voltage. 
Work may only be performed on the pump or on the equipment connected to it after 
disconnection from power sources and after disconnecting the starting device.

4.8 

The operating safety of the pump is only guaranteed if the installation and service 
instructions are correctly followed.

4.9 

The limit values stated in the technical table should not be exceeded under any 
condition.

4.10 

In the event of defective operation or fault, contact the manufacturer’s technical 
support department or its nearest authorised agents.

4.11 

If the supply cord is damaged, it must be replaced by an authorised service agent.

4.12 

This appliance is not intended for use by children or persons with reduced physical, 
sensory or mental capabilities or lack of experience and knowledge unless they have 
been given supervision or instruction concerning the use of the appliance by a person 
responsible for their safety.

Summary of Contents for Evoflow TUF









Reviews: