www.evolutionpowertools.com
10
• To remove the Battery Pack, simply press
the two locking tabs with your finger and
thumb and slide the Battery Pack from the
handle.
3. INSTALLING OR
REMOVING A BLADE (Fig. 2)
Note:
The Battery Pack must be disconnected
from the machine when installing or removing
the blade.
Installation:
• Remove the Battery Pack.
• Check that the jigsaw blade is of the
correct type.
• Pull back on the collet chuck sleeve using
your finger and thumb of one hand.
• Insert the blade into the chuck fully
ensuring that the blade teeth face forwards.
• Release the chuck sleeve.
• Check to ensure the blade is securely
gripped by the chuck.
• Check to ensure that the back of the blade
has engaged into the groove in the guide
roller.
(Fig. 3)
• Replace the battery pack.
Removal:
Note:
A recently used blade can be very
hot. Allow such a blade to cool down before
attempting to remove it from the machine.
• Stop the machine with the chuck at the
bottom of its stroke.
• Remove the Battery Pack.
• Set the Cutting Action Selection Switch to
position 3.
• Pull back on the collet chuck sleeve using
your finger and thumb of one hand.
• Using your other hand gently ease the
blade rearward to release any pressure
being exerted by the guide roller on the
back of the blade.
• Pull the blade downwards and away from
the machine.
4. ON/OFF TRIGGER SWITCH (Fig. 4a)
This tool is fitted with a variable speed Trigger
Switch that delivers higher speed as the
trigger pressure is increased.
The Trigger Switch is also fitted with a brake
function which stops the chuck immediately
when you quickly release the trigger.
FIG: 2
FIG: 3