MaxBAR 210 Manual Ver. 1.00
Page
17
o
Troubleshooting
Following are a few common problems that may occur during operation. Here are some
suggestions for easy troubleshooting:
The fixture does not work, no light
o
Check the connection of power and main fuse.
o
Measure the mains voltage on the main connector.
Not responding to DMX controller
o
DMX LED should be on. If not, check DMX connectors, cables to see if link
properly.
o
If the DMX LED is on and no response to the channel, check the address settings
and DMX polarity.
o
If you have intermittent DMX signal problems, check the pins on connectors or
on PCB of the fixture or the previous one.
o
Try to use another DMX controller.
o
Check if the DMX cables run near or run alongside to high voltage cables that
may cause damage or interference to DMX interface circuit.
Some fixtures don’t respond to the easy controller
o
You may have a break in the DMX cabling.
o
Check the LED for the response of the master/ slave mode signal.
No response to the sound
o
Make sure the fixture does not receive DMX signal.
o
Check microphone to see if it is good by tapping the microphone.
Technical Specifications
Model
MaxBAR 210 IP65
Voltage
110V- 250V / 50-60Hz
Power consumption:
210W
LED
42 pcs 5 Watts RGB 3 in 1
Weight
5.5 kg
Dimensions
535 x 153 x 182 mm
