7
EvoHeat Fusion-i Series Manual
4. Safety Instructions
Installation, repair or relocations must be done by a fully qualified person and not by the customer. If done
incorrectly it may cause fire, electric shock, water leakage and other hazards.
A circuit breaker must be installed for the unit.
To avoid risk of electrical shock, the unit must have a good power connection and earthing.
The unit is equipped with an over-load protection system. After a previous stoppage, the unit will not start for at
least 3 minutes.
Do not use any means to accelerate the defrosting processor or to clean other than those
recommended by the manufacturer.
The unit must be stored in a room without any continuously operating ignition sources
(for example: open flames, an operating gas appliance or an operating electric heater.)
Do not pierce or burn.
Be aware that refrigerants may not contain an odour.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
The appliance shall be installed in accordance with national wiring regulations.
Before obtaining access to terminals, all supply circuits must be disconnected.
An all-pole disconnection device must be incorporated which as at least 3mm clearances in all poles, a leakage
current that may exceed 10mA, residual current device (RCD) having a rated residual operating current not
exceeding 30mA and disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
The unit should be installed, operated and stored in a room with a floor area larger than 30m2.
-
The installation of pipe-work shall be kept to a minimum 30 m2
-
Spaces where refrigerant pipes shall be compliance with national gas regulations.
-
Servicing shall be performed only as recommended by the manufacturer.
-
The appliance shall be stored in a well-ventilated area where the room size corresponds to the room area as
specified for operation.
-
All working procedure that affects safety means shall only be carried by competent persons.
Transport of equipment containing flammable refrigerants
-
Compliance with the transport regulations
-
Marking of equipment using signs
-
Compliance with local regulations
-
Disposal of equipment using flammable refrigerants
-
Compliance with national regulations
-
Storage of equipment/appliances
-
The storage of equipment should be in accordance with the manufacturer's instructions. Storage of packed
(unsold) equipment
-
Storage package protection should be constructed such that mechanical damage to the equipment inside
the package will not cause a leak of the refrigerant charge.
-
The maximum number of pieces of equipment permitted to be stored together will be determined by local
regulations.
Use supply wires suitable for 75°C
* Caution: Single wall heat exchanger, not suitable for potable water connection.