Evocare LM9712, Owner'S Manual

Page: 7 / 15

Page 7.
WARNING
After any adjustments, and before use, make sure all attaching hardware is
tightened securely. Otherwise, injury or damage may result.
Installing Swingaway Removable Legrest Assembly
NOTE: For this procedure refer to FIGURE 1.
1. Turn the footrest to the side (open footplate perpendicular to transport
wheelchair).
2. Install the hinge plates on the footrest
onto the hinge pins on the transport
wheelchair frame.
3. Push the footrest towards the inside
of the transport chair until it locks into
place.
NOTE: The footplate will be on the inside
of the transport wheelchair when locked in
place.
4. Repeat this procedure for the other
footrest assembly.
5. To release the footrest, push the
footrest release lever inward, rotate
the footrest outward.
Adjusting Footplate Height
NOTE: For this procedure, refer to FIGURE 2.
This needs to be done BEFORE using the wheelchair. For your convenience you may find that
the bolt at the bottom of the footplate is loosened so you may adjust then tighten before use.
1. Remove the swing-away footrest assembly.
NOTE: lay the assembly on a flat surface to simplify this procedure.
2. Loosen, but DO NOT remove, the
footplate mounting bolt until the
footplate assembly moves freely.
3. Reposition the footplate assembly to
the desired height.
4. Securely tighten the footplate
mounting bolt.
5. Repeat this procedure for the other
footrest, if necessary.
6. Reinstall the swing-away footrest
assembly.