EVOC P12 Series, Manual

Page: 20 / 131

Application Scheme
P12 SERIES · 11 ·
 Please keep the documentation at a safe place.The documentation, which is a part of
the device,is required for initial device debugging.
 When doing the initial examination,please check whether there are distinct damages to
the device caused during the transport.
 Please check whether the delivery contains the intact device and all of the
independently ordered accessories.Please contact the customer service when any
unconformity or transportation damages occur.
2.3.2 Markings for PC Identification
Attention
When the product needs to be repaired or after it has been stolen,these codes can be used
to identify the PC.Please do not rip them off.
Serial number:located on the chassis body (as shown below)
2.4 External Environment Conditions
The following conditions should be considered when planning the project:
 The weather and mechanical environment conditions specified in the operation manual
should be observed.
 Please avoid extreme enviroment conditions.The PC should be protected against
dust,moisture and heat.
 Please avoid direct exposure to sunlight.
 Please make sure that other assemblies and side of cabinet are at least 50mm and
100mm away from the top and below the PC respectively.
 Please do not block the ventilation hole of the PC(If have).
 The installation position requirement for the PC should be always observed.
 The connected or installed I/O should not generate reverse voltage of more than 0.5V
inside the PC.