EVN SmartHome Wandthermostat Plus, Operating Manual

Page: 19 / 31

36 37
• Set the year, month and date and confirm each setting
with the OK button.
Year: Month and day:
• Now set the time and confirm settings with the OK button.
Hours: Minutes:
Once the time and date were entered, the EVN SmartHome
wall thermostat switches to normal operation.
If the EVN SmartHome wall thermostat was taught-
in to the EVN SmartHome cube, the current date and
time will be transferred to the EVN SmartHome wall
thermostat automatically.
During operation without the EVN SmartHome Cube
date and time can be changed at any time via „dAt“
in the configuration menu (see section 17).
8. Mounting
You can either use screws or adhesive strips to mount the
EVN SmartHome wall thermostat to a wall in the frame
supplied or integrate it into an existing switch (please re-
fer to sec. 9).
Adhesive strip mounting:
• Choose a site for installation. The surface on which you
are mounting the EVN SmartHome Wall The
must be clean, dry and greaseless.
• For mounting of the assembled EVN SmartHome Wall
The, attach the adhesive strips to the back side
of the mounting plate. You should be able to read the let-
ters on the back side (according to figure).
• Remove the protective film from the adhesive strip.
• Press the assembled EVN SmartHome Wall Thermos-
tat+ with the back side to the wall in the position where
it should subsequently be attached.
Screw mounting:
• Choose a site for installation.
Make sure that electrical lines in the wall will not be
damaged.
• Position the mounting plate on the desired site on the
wall. Make sure that the arrow on the mounting plate is
pointing upwards.