11
SZX2-ILLTQ/ILLTS
33
Operating procedures of each portion
Set the main switch A to (ON).
Rotating the brightness control knob B in the direction of the arrow
increases the brightness of the illumination light
1
2
SZX2-ILLTQ
You can change the illumination method by rotating the illumination selection turret.
Up to four illumination cartridges can be attached.
(For procedures to attach the illumination cartridge, see page 20.)
Rotate the illumination selection turret A (also available to operate
on the left side) to the click position.
You can confirm the selected illumination method by the illumination
cartridge name B visible through the stage glass.
SZX2-ILLTS
You can change the illumination method by replacing the illumination
cartridge. (For procedures to replace the illumination cartridge, see page 20.)
1
You can select the best illumination method by changing the illumination cartridge according to the sample. For compatible
cartridges, see page 18.
This section describes the basic operating procedure of each portion.
A
B
2
Rotate the oblique illumination control knob A on the front by pushing
it in and then turning it to the left or right, and adjust the effectiveness
of oblique illumination.
· Adjust the effectiveness of oblique illumination when you use
the oblique cartridge (SZX2-COB, SZX2-COBH or SZX2-COBL).
· You can check the degree of oblique of the illumination
with the scale B on the cartridge. The oblique range of the
illumination is between the short scale and the long scale.
Do not rotate the oblique illumination control knob with
excess force.
1
TIP
NOTE
1
Turning ON the main switch and adjusting the brightness
2
Changing the illumination
3
Adjusting Oblique (Oblique brightfield illumination)
A
B
A
B
