7
VIBRATION
Vibration characteristic value=
3.14 m/s
2
These values are determined and documented in accordance to ISO 8662-11.
This value is a tool-related characteristic value and does not represent the influence to the hand-arm-system when
using the tool. An influence to the hand-arm-system when using the tool will, for example, depend on the gripping
force, the contact pressure force, the working direction, the adjustment of mains supply and the workpiece support.
OPERATION
Refer to Operation Instructions and warnings on pages before proceeding to use this tool.
THIS TOOL IS EQUIPPED WITH A TRIGGER THAT HAS DUAL PURPOSE
SCN65, SCN65B, SCN65T, SCN66 ARE EQUIPPED WITH A SMART TRIGGER THAT HAS DUAL PURPOSE
SMART TRIGGER:
IDENTIFIED BY RED TRIGGER
CONTINUOUS BUMP FIRE OPERATION
WITH SMART TRIGGER
The common operating procedure on
“Contact
T
rip”
tools is for the operator to contact the work to actuate the trip
mechanism while keeping the trigger pulled, thus driving a fastener each time the work is contacted. This will
allow rapid fastener placement on many jobs, such as sheathing, decking and pallet assembly. All pneumatic
tools are subject to recoil when driving fasteners. The tool may bounce, releasing the trip, and if unintentionally
allowed to recontact the work surface with the trigger still actuated (finger still holding trigger pulled) an unwanted
second fastener will be driven.
(see detailed illustration hereunder)
SINGLE SEQUENTIAL FIRE OPERATION WITH SMART TRIGGER
For single fire operation, depress the Contact Arm against the work piece and pull the Trigger. Tool cannot fire a
second nail until the Trigger is released and tool can cycle.
(see detailed illustration hereunder)
