evertz CP-2272E, User Manual

Page: 20 / 28

CP-2272E
Page 12
Revision 1.0
5. SYSTEM CONFIGURATION
5.1. UPGRADING THE CP-2272E PANEL
5.1.1. System Requirements
1. The user must have a laptop or PC connected to the same network as the CP-2272E.
2. In order to run the EQX / MAGNUM, you must have one of the following browsers installed on
your machine: Firefox, Chrome or Safari.
5.1.2. Identifying the IP Address
The IP Address can be identified using the procedure outlined below or by referring to section 4.2.1.1.
1. To identify the IP address, hold down the top and bottom rotary encoders (T1 and BM4) for
approximately 6 seconds.
2. When the main engineering menu appears, push to the
SETUP menu button.
3. Next, select the
IP Addr option and push in the Menu rotary encoder once again. Obtain the IP
address, which will appear on the third display screen.
4. At this time, ensure that one of the above mentioned browsers from section 5.1.1 is installed on
your machine.

Please note that the CP-2272E and the PC must be on the same network.
5.1.3. Upgrading Firmware on the CP-2272E
1. To upgrade firmware using the web interface, open a firefox web browser and enter the IP
address of the CP-2272E into the address field, and then press the < enter> key. The CP-2272E
Web Updater screen will appear, as shown in Figure 5-1.
Figure 5-1: CP2272e Main Screen